Denial of Motor Vehicle Defect Petition |
|---|
Topics: Michelin
|
Jeffrey M. Giuseppe
National Highway Traffic Safety Administration
27 August 2018
[Federal Register Volume 83, Number 166 (Monday, August 27, 2018)]
[Notices]
[Pages 43733-43735]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2018-18506]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
National Highway Traffic Safety Administration
[Docket No. NHTSA-2018-0062]
Denial of Motor Vehicle Defect Petition
AGENCY: National Highway Traffic Safety Administration (NHTSA),
Department of Transportation (DOT).
ACTION: Denial of petition for a defect investigation.
-----------------------------------------------------------------------
SUMMARY: This is a notice of denial of a petition submitted to the
National Highway Traffic Safety Administration (NHTSA) under 49 U.S.C.
30162, requesting that the Agency commence a proceeding to determine
the existence of a defect related to motor vehicle safety in Michelin
Model XZU-3, size 305/85/R22.5 Load Range J transit bus tires. After a
review of the petition and other information, NHTSA has concluded that
a defects investigation is unlikely to result in a finding that a
defect related to motor vehicle safety exists, or a NHTSA order for the
notification and remedy of a safety related defect as alleged, at the
conclusion of the requested investigation.
FOR FURTHER INFORMATION CONTACT: Bruce York, Medium & Heavy Duty
Vehicle Division, Office of Defects Investigation, NHTSA, 1200 New
Jersey Ave. SE, Washington, DC 20590. Email: Bruce.York@dot.gov.
SUPPLEMENTARY INFORMATION: By letter dated July 14, 2016, Paul Koleber
from Intercity Transit wrote to NHTSA requesting that the Agency
investigate the existence of a defect related to motor vehicle safety
in Michelin Model XZU-3, size 305/85/R22.5 Load Range J transit bus
tires. Mr. Koleber alleges the tires are structurally unsound and that
this defect can result in sidewall blowouts at any time whether the
tires are new or re-tread. Mr. Koleber stated that Michelin had
previously recalled similar tires (12T-009) and the Intercity Transit
fleet experienced failures with the same characteristics as those
specified in the recall. Mr. Koleber submitted a forensics lab report
from CASE Forensics to support his allegation.
NHTSA has reviewed the material provided by the petitioner and
other information. The results of this review and NHTSA's analysis of
the petition are set forth in the DP17-001 Evaluation Report, published
in its entirety as an appendix to this notice.
For the reasons presented in the DP17-001 Evaluation Report, it is
unlikely that a defects investigation will result in a finding that a
defect related to motor vehicle safety exists. It is also unlikely that
an order for the notification and remedy of a safety-related defect
would be issued as a result of granting Mr. Koleber's request.
Therefore, the petition is denied. This action does not constitute a
finding by NHTSA that a safety related defect does not exist. The
Agency will take further action if warranted by future circumstances.
Authority: 49 U.S.C. 30162(d); delegations of authority at CFR
1.50 and 501.8.
Jeffrey M. Giuseppe,
Associate Administrator for Enforcement.
Nate Seymour
Safety Defects Engineer
NEF-106ns
DP17-001
BASIS:
Paul Koleber, from Intercity Transit petitioned the National
Highway Traffic Safety Administration (NHTSA) by letter dated July 14,
2016, requesting that a defect investigation be conducted concerning
motor vehicle safety in Michelin Model XZU-3, size 305/85/R22.5 Load
Range J transit bus tires. The facts described in this report are based
on the Office of Defect Investigations' (ODI) assessment of the
information provided by the petitioner and information gathered by ODI
from relevant sources.
The petitioner alleged that a defect exists involving the design of
tires used in commercial bus operations which have resulted in rapid
air loss. The petitioner claimed that failures identical to those
described in recall 12T-009 have happened on the subject post recall
tires. The petitioner stated that failures occurred on steer and drive
wheel positions of both new and retread tires. The petitioner hired a
forensics lab to perform scientific failure analysis of failed tires.
The lab concluded the tires were of similar design and construction to
those in recall 12T-009 and that the failures were caused by corrosion
induced degradation of the ply strands.
DESCRIPTION OF TIRE:
The subject tires are Michelin XZU-3, size 305/85/R22.5 Load Range
J transit bus tires. They are designed to be
[[Page 43734]]
used in all wheel positions for urban operations involving frequent
stopping and starting. The tread pattern is non-directional and
designed for efficient traction on wet and slippery surfaces through
Michelin's patented Matrix Siping technology. The tires have a robust
casing and bead design to allow for retreading. The sidewalls are extra
thick to resist curb scrub and include scrub depth indicators to aid
inspection of the tires to help extend casing life.
OWNER REPORTS:
The Office of Defects Investigation received two (2) complaints
related to Michelin XZU-3 transit bus tires. The first Vehicle Owner's
Questionnaire (VOQ) was received in April 2012, the same month that
voluntary recall 12T-009 was received from Michelin. A second VOQ was
received in April 2017, one month after DP17-001 was opened to assess
failures on Michelin XZU-3 transit bus tires. Both reports were
submitted by transit fleets. Neither VOQ alleged any crashes, injuries
or fatalities.
ANALYSIS:
On March 23, 2017, ODI sent Michelin an Information Request letter
asking for information related to the subject tires. Michelin's
response was received May 5, 2017, where design and application data
were presented. ODI's assessment of that data follows.
Michelin reported a tire population (2012-2014 production) of
17,487 subject tires. The subject tire was discontinued in 2014, upon
the introduction of the X InCity Z 305/85R22.5 LRJ tire, which offers
increased scrub resistance. The initial tread life of the subject tire
is expected to range from 60,000 to 100,000 miles. The casing life is
expected to range from two (2) to four (4) years, with one (1) to three
(3) retread applications. Therefore, a limited number of subject tires
are believed to still be in service.
When asked how Michelin determined the recall population for 12T-
009, Michelin stated that the bead design of the recalled tires had
undergone a design change. A reduction in the number of strands was
determined to be the cause of failures associated with recall 12T-009.
Once the defect was identified, Michelin reinstated the original bead
design specification, which marked the endpoint of the recall
population. The scope of the recalled tires included tires manufactured
from the date of the bead design change through the date when the
design was changed back to the original specification.
The tires identified by the petitioner were produced after the bead
design was corrected.
Michelin queried its databases and found no complaints and one
claim for property damage on tires manufactured after the 12T-009
recall scope. Michelin denied this claim based on the following.
Michelin evaluated twelve (12) tires from the fleet. All had been
retreaded one time, but not at a Michelin Retread Technologies (MRT)
approved facility. Michelin's analysis of the tires revealed
operational or maintenance failures in ten (10) of the twelve (12)
tires. These tires had high levels of moisture and damage or evidence
of damage repair adjacent to the rupture. The combination of these
conditions allows for corrosion to develop in the belt package, which
leads to failure. The other two (2) could not be determined. ODI
queried its database and found one (1) Vehicle Owner Questionnaire
(VOQ) related to the subject population, which was received after the
investigation was opened. In March 2017, Michelin visited the fleet
that submitted the VOQ, and analyzed its tires. Similar to the property
damage claim above, an MRT was not used. Nor was an air dryer for tire
inflation. This leaves in question the integrity of the casings and
moisture content which is detrimental to tire life. Michelin submitted
to ODI, inspection documentation. Reports of the tires showed signs of
overloading. Personnel interviews supported these findings as the fleet
followed the vehicle manufacturer's recommended inflation pressure,
which is known to be inadequate for true operational loads on the
specific vehicles operated by the fleet.
MRT facilities utilize inspection equipment not available to out of
network retread facilities. The use of Grazing Light Inspection, X-ray,
and Casing Integrity Analyzer (CIA) minimize the risk of tire failure
after retreading. MRT facilities also utilize approved processes to
repair tire damage prior to retreading to prevent moisture from
entering the belt package.
The Altoona Bus Study, Michelin's weight study of fleet buses, and
ODI's weight study are all in agreement. Each independently found that
the Gillig Low Floor 40' transit bus as used by the petitioner and
other fleets would be overloaded with a foreseeable load. And, the
greatest overloading would occur at the left rear wheel-end. ODI went
further to assess the average passenger weight. ODI found that the 150-
pound weight specified in the Code of Federal Regulations (CFR), 49
C.F.R. Part 567.4(g)(3) and Subtitle B-Chapter VI Part 665 Subpart A is
not representative of today's population. The 150-pound value was
established in 1971 based on data derived from the National Health
Examination Survey from 1960-1962. A more recent value from the
National Center for Health Statistics determined the average male and
female weight to be 195 and 165 respectively. In both cases, the study
participants were not truck/bus drivers or transit passengers. ODI
notes that a luggage allowance for each passenger is necessary given
the vehicle usage. ODI also surveyed heavy vehicle manufacturers to
learn what design weight they use for the driver. Responses ranged from
150 to 312 pounds depending on market. The Federal Transit Authority
(FTA) initiated a Notice of Proposed Rulemaking (NPRM) action in 2011,
to increase the average passenger weight and standing passenger floor
space square footage, but this rule was never enacted.
As required by 49 CFR part 567, the vehicle manufacturer is
responsible for the data on the vehicle certification label. The
manufacturer will set the tire pressure based on the anticipated axle
load. The anticipated loads will drive the selection of components to
meet the owner's specifications.
Michelin released a Technical Bulletin in November 2015,
recommending 120 psi be used in all subject tires. Michelin met with
Gillig in January 2016, and recommended the use of 315/80R22.5 tires
and an inflation pressure of 120 psi to provide sufficient load-
carrying capacity to support actual loads. Gillig, who produced the
petitioner's buses, elected not to adopt this action.
CONCLUSION:
Based on the available information and previous agency experience,
ODI believes the tires manufactured after those identified in recall
12T-009 failed as a result of overloading by the fleets operating the
buses. In our view, a defects investigation is unlikely to result in a
finding that a defect related to motor vehicle safety exists, or a
NHTSA order for the notification and remedy of a safety related defect
as alleged, at the conclusion of the requested investigation.
Therefore, given a thorough analysis of the potential for finding a
safety related defect in the vehicle, and in view of NHTSA's
enforcement priorities and its previous investigations into this issue,
the petition is denied. This action does not constitute a finding by
NHTSA that a safety related defect does not exist. The
[[Page 43735]]
Agency will take further action if warranted by future circumstances.
RECOMMENDATION:
Deny the petition.
CONCUR:
Bruce York, Chief
Medium and Heavy Duty Vehicle
Defects & Assessment Division
[FR Doc. 2018-18506 Filed 8-24-18; 8:45 am]
BILLING CODE 4910-59-P