Receipt of Petition for Decision That Nonconforming 1989 Honda Civic DX Hatchback Passenger Cars Are Eligible for Importation Publication: Federal Register Agency: National Highway Traffic Safety Administration Byline: Marilynne Jacobs Date: 30 May 1995 Subject: American Government • Safety Topic: Honda Civic

[Federal Register Volume 60, Number 103 (Tuesday, May 30, 1995)]
[Notices]
[Pages 28201-28202]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 95-13168]



-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION
National Highway Traffic Safety Administration
[Docket No. 95-44; Notice 1]


Receipt of Petition for Decision That Nonconforming 1989 Honda 
Civic DX Hatchback Passenger Cars Are Eligible for Importation

AGENCY: National Highway Traffic Safety Administration, DOT.

ACTION: Notice of receipt of petition for decision that nonconforming 
1989 Honda Civic DX Hatchback passenger cars are eligible for 
importation.

-----------------------------------------------------------------------

SUMMARY: This notice announces receipt by the National Highway Traffic 
Safety Administration (NHTSA) of a petition for a decision that a 1989 
Honda Civic DX Hatchback that was not originally manufactured to comply 
with all applicable Federal motor vehicle safety standards is eligible 
for importation into the United States because (1) it is substantially 
similar to a vehicle that was originally manufactured for importation 
into and sale in the United States and that was certified by its 
manufacturer as complying with the safety standards, and (2) it is 
capable of being readily altered to conform to the standards.

DATE: The closing date for comments on the petition is June 29, 1995.

ADDRESS: Comments should refer to the docket number and notice number, 
and be submitted to: Docket Section, Room 5109, National Highway 
Traffic Safety Administration, 400 Seventh St., SW., Washington, DC 
20590. [Docket hours are from 9:30 am to 4 pm]

FOR FURTHER INFORMATION CONTACT:
George Entwistle, Office of Vehicle Safety Compliance, NHTSA (202-366-
5306).

SUPPLEMENTARY INFORMATION:

Background

    Under 49 U.S.C. 30141(a)(1)(A) (formerly section 108(c)(3)(A)(i)(I) 
of the National Traffic and Motor Vehicle Safety Act (the Act)), a 
motor vehicle that was not originally manufactured to conform to all 
applicable Federal motor vehicle safety standards shall be refused 
admission into the United States unless NHTSA has decided that the 
motor vehicle is substantially similar to a motor vehicle originally 
manufactured for importation into and sale in the United States, 
certified under 49 U.S.C. 30115 (formerly section 114 of the Act), and 
of the same model year as the model of the motor vehicle to be 
compared, and is capable of being readily altered to conform to all 
applicable Federal motor vehicle safety standards.
    Petitions for eligibility decisions may be submitted by either 
manufacturers or importers who have registered with NHTSA pursuant to 
49 CFR part 592. As specified in 49 CFR 593.7, NHTSA publishes notice 
in the Federal Register of each petition that it receives, and affords 
interested persons an opportunity to comment on the petition. At the 
close of the comment period, NHTSA decides, on the basis of the 
petition and any comments that it has received, whether the vehicle is 
eligible for importation. The agency then publishes this decision in 
the Federal Register.
    J.K Motors of Kingsville, Maryland (``J.K.'') (Registered Importer 
90-006) has petitioned NHTSA to decide whether 1989 Honda Civic DX 
Hatchback passenger cars are eligible for importation into the United 
States. The vehicle which J.K. believes is substantially similar is the 
1989 Honda Civic DX Hatchback that was manufactured for importation 
into, and sale in, the United States and certified by its manufacturer 
as conforming to all applicable Federal motor vehicle safety standards.
    The petitioner claims that it carefully compared the non-U.S. 
certified 1989 Honda Civic DX Hatchback to its U.S. certified 
counterpart, and found the two vehicles to be substantially similar 
with respect to compliance with most Federal motor vehicle safety 
standards.
    J.K. submitted information with its petition intended to 
demonstrate that the non-U.S. certified 1989 Honda Civic DX Hatchback, 
as originally manufactured, conforms to many Federal motor vehicle 
safety standards in the same manner as its U.S. certified counterpart, 
or is capable of being [[Page 28202]] readily altered to conform to 
those standards.
    Specifically, the petitioner claims that the non-U.S. certified 
1989 Honda Civic DX Hatchback is identical to its U.S. certified 
counterpart with respect to compliance with Standards Nos. 102 
Transmission Shift Lever Sequence * * *,. 103 Defrosting and Defogging 
Systems, 104 Windshield Wiping and Washing Systems, 105 Hydraulic Brake 
Systems, 106 Brake Hoses, 107 Reflecting Surfaces, 109 New Pneumatic 
Tires, 113 Hood Latch Systems, 116 Brake Fluid, 124 Accelerator Control 
Systems, 201 Occupant Protection in Interior Impact, 202 Head 
Restraints, 203 Impact Protection for the Driver From the Steering 
Control System, 204 Steering Control Rearward Displacement, 205 Glazing 
Materials, 206 Door Locks and Door Retention Components, 207 Seating 
Systems, 209 Seat Belt Assemblies, 210 Seat Belt Assembly Anchorages, 
211 Wheel Nuts, Wheel Discs and Hubcaps, 212 Windshield Retention, 216 
Roof Crush Resistance, 219 Windshield Zone Intrusion, 301 Fuel System 
Integrity, and 302 Flammability of Interior Materials.
    Petitioner also contends that the vehicle is capable of being 
readily altered to meet the following standards, in the manner 
indicated:
    Standard No. 101 Controls and Displays: (a) Substitution of a lens 
marked ``Brake'' for a lens with an ECE symbol on the brake failure 
indicator lamp; (b) recalibration of the speedometer/odometer from 
kilometers to miles per hour.
    Standard No. 108 Lamps, Reflective Devices and Associated 
Equipment: (a) Installation of U.S.-model headlamps and front 
sidemarkers; (b) installation of U.S.-model taillamp assemblies which 
incorporate rear sidemarkers; (c) installation of a high mounted stop 
lamp.
    Standard No. 110 Tire Selection and Rims: Installation of a tire 
information placard.
    Standard No. 111 Rearview Mirror: Replacement of the passenger side 
rearview mirror with a U.S.-model component.
    Standard No. 114 Theft Protection: Installation of a key 
microswitch and a warning buzzer in the steering lock assembly.
    Standard No. 115 Vehicle Identification Number: Installation of a 
VIN plate that can be read from outside the left windshield pillar, and 
a VIN reference label on the edge of the door or latch post nearest the 
driver.
    Standard No. 118 Power Window Systems: Installation of a relay in 
the power window system so that the window transport is inoperative 
when the ignition is switched off.
    Standard No. 208 Occupant Crash Protection: Installation of a seat 
belt warning buzzer, wired to the seat belt latch. The petitioner 
states that the vehicle is equipped with U.S.-model shoulder belts in 
both front and rear outboard seating positions.
    Standard No. 214 Side Impact Protection: Installation of 
reinforcing beams.
    Additionally, the petitioner states that the bumpers on the non-
U.S. certified 1989 Honda Civic DX Hatchback must be reinforced with 
steel support structures to comply with the Bumper Standard found in 49 
CFR part 581.
    Interested persons are invited to submit comments on the petition 
described above. Comments should refer to the docket number and be 
submitted to: Docket Section, National Highway Traffic Safety 
Administration, Room 5109, 400 Seventh Street, SW., Washington, DC 
20590. It is requested but not required that 10 copies be submitted.
    All comments received before the close of business on the closing 
date indicated above will be considered, and will be available for 
examination in the docket at the above address both before and after 
that date. To the extent possible, comments filed after the closing 
date will also be considered. Notice of final action on the petition 
will be published in the Federal Register pursuant to the authority 
indicated below.

    Authority: 49 U.S.C. 30141(a)(1)(A) and (b)(1); 49 CFR 593.8; 
delegations of authority at 49 CFR 1.50 and 501.8.

    Issued on: May 24, 1995.
Marilynne Jacobs,
Director, Office of Vehicle Safety Compliance.
[FR Doc. 95-13168 Filed 5-26-95; 8:45 am]
BILLING CODE 4910-59-M