Notice of Receipt of Petition for Decision that Nonconforming 1988 Volvo 740 Sedans Are Eligible for Importation Publication: Federal Register Agency: National Highway Traffic Safety Administration Byline: William A. Boehly Date: 27 September 1994 Subject: American Government • Safety Topic: Volvo 740

[Federal Register Volume 59, Number 186 (Tuesday, September 27, 1994)]
[Unknown Section]
[Page 0]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 94-23872]


[[Page Unknown]]

[Federal Register: September 27, 1994]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION
[Docket No. 94-77; Notice 1]

 

Notice of Receipt of Petition for Decision that Nonconforming 
1988 Volvo 740 Sedans Are Eligible for Importation

AGENCY: National Highway Traffic Safety Administration, DOT.

ACTION: Notice of receipt of petition for decision that nonconforming 
1988 Volvo 740 Sedans are eligible for importation.

-----------------------------------------------------------------------

SUMMARY: This notice announces receipt by the National Highway Traffic 
Safety Administration (NHTSA) of a petition for a decision that a 1988 
Volvo 740 Sedan that was not originally manufactured to comply with all 
applicable Federal motor vehicle safety standards is eligible for 
importation into the United States because (1) It is substantially 
similar to a vehicle that was originally manufactured for importation 
into and sale in the United States and that was certified by its 
manufacturer as complying with the safety standards, and (2) it is 
capable of being readily altered to conform to the standards.

DATES: The closing date for comments on the petition is October 27, 
1994.

ADDRESSES: Comments should refer to the docket number and notice 
number, and be submitted to: Docket Section, Room 5109, National 
Highway Traffic Safety Administration, 400 Seventh St., SW., 
Washington, DC 20590. [Docket hours are from 9:30 a.m. to 4 p.m.]

FOR FURTHER INFORMATION CONTACT:
Ted Bayler, Office of Vehicle Safety Compliance, NHTSA (202-366-5306).

SUPPLEMENTARY INFORMATION:

Background

    Under 49 U.S.C. Sec. 30141(a)(1)(A) (formerly section 
108(c)(3)(A)(i)(I) of the National Traffic and Motor Vehicle Safety Act 
(the Act)), a motor vehicle that was not originally manufactured to 
conform to all applicable Federal motor vehicle safety standards shall 
be refused admission into the United States unless NHTSA has decided 
that the motor vehicle is substantially similar to a motor vehicle 
originally manufactured for importation into and sale in the United 
States, certified under 49 U.S.C. Sec. 30115 (formerly section 114 of 
the Act), and of the same model year as the model of the motor vehicle 
to be compared, and is capable of being readily altered to conform to 
all applicable Federal motor vehicle safety standards.
    Petitions for eligibility decisions may be submitted by either 
manufacturers or importers who have registered with NHTSA pursuant to 
49 CFR Part 592. As specified in 49 CFR 593.7, NHTSA publishes notice 
in the Federal Register of each petition that it receives, and affords 
interested persons an opportunity to comment on the petition. At the 
close of the comment period, NHTSA decides, on the basis of the 
petition and any comments that it has received, whether the vehicle is 
eligible for importation. The agency then publishes this decision in 
the Federal Register.
    Western Cascade of Seattle, Washington (Registered Importer 94-23) 
has petitioned NHTSA to decide whether 1988 Volvo 740 Sedans are 
eligible for importation into the United States. The vehicle which 
Western Cascade believes is substantially similar is the 1988 Volvo 740 
Sedan that was manufactured for importation into, and sale in, the 
United States and certified by its manufacturer as conforming to all 
applicable Federal motor vehicle safety standards.
    The petitioner claims that it carefully compared the non-U.S. 
certified 1988 Volvo 740 Sedan to its U.S. certified counterpart, and 
found the two vehicles to be substantially similar with respect to 
compliance with most Federal motor vehicle safety standards.
    Western Cascade submitted information with its petition intended to 
demonstrate that the non-U.S. certified 1988 Volvo 740 Sedan, as 
originally manufactured, conforms to many Federal motor vehicle safety 
standards in the same manner as its U.S. certified counterpart, or is 
capable of being readily altered to conform to those standards.
    Specifically, the petitioner claims that the non-U.S. certified 
1988 Volvo 740 Sedan is identical to its U.S. certified counterpart 
with respect to compliance with Standards Nos. 102 Transmission Shift 
Lever Sequence * * *, 103 Defrosting and Defogging Systems, 104 
Windshield Wiping and Washing Systems, 105 Hydraulic Brake Systems, 106 
Brake Hoses, 107 Reflecting Surfaces, 109 New Pneumatic Tires, 111 
Rearview Mirror, 113 Hood Latch Systems, 116 Brake Fluid, 118 Power 
Window Systems, 124 Accelerator Control Systems, 201 Occupant 
Protection in Interior Impact, 202 Head Restraints, 203 Impact 
Protection for the Driver From the Steering Control System, 204 
Steering Control Rearward Displacement, 205 Glazing Materials, 206 Door 
Locks and Door Retention Components, 207 Seating Systems, 208 Occupant 
Crash Protection, 209 Seat Belt Assemblies, 210 Seat Belt Assembly 
Anchorages, 211 Wheel Nuts, Wheel Discs and Hubcaps, 212 Windshield 
Retention, 214 Side Door Strength, 216 Roof Crush Resistance, 219 
Windshield Zone Intrusion, 301 Fuel System Integrity, and 302 
Flammability of Interior Materials.
    Petitioner also contends that the vehicle is capable of being 
readily altered to meet the following standards, in the manner 
indicated:
    Standard No. 101 Controls and Displays: recalibration of the 
speedometer/odometer from kilometers to miles per hour.
    Standard No. 108 Lamps, Reflective Devices and Associated 
Equipment: (a) Installation of U.S.-model sealed beam headlamps; (b) 
installation of a high mounted stop lamp.
    Standard No. 110 Tire Selection and Rims: installation of a tire 
information placard.
    Standard No. 114 Theft Protection: installation of a warning buzzer 
in the steering lock assembly.
    Standard No. 115 Vehicle Identification Number: installation of a 
VIN plate that can be read from outside the left windshield pillar, and 
a VIN reference label on the edge of the door or latch post nearest the 
driver.
    Additionally, the petitioner states that shock absorbers must be 
installed behind the bumpers on the non-U.S. certified 1988 Volvo 740 
Sedan to comply with the Bumper Standard found in 49 CFR Part 581.
    Interested persons are invited to submit comments on the petition 
described above. Comments should refer to the docket number and be 
submitted to: Docket Section, National Highway Traffic Safety 
Administration, Room 5109, 400 Seventh Street, SW., Washington, DC 
20590. It is requested but not required that 10 copies be submitted.
    All comments received before the close of business on the closing 
date indicated above will be considered, and will be available for 
examination in the docket at the above address both before and after 
that date. To the extent possible, comments filed after the closing 
date will also be considered. Notice of final action on the petition 
will be published in the Federal Register pursuant to the authority 
indicated below.

    Authority: 49 U.S.C. 30141 (a)(1)(A) and (b)(1); 49 CFR 593.8; 
delegations of authority at 49 CFR 1.50 and 501.8

    Issued on: September 22, 1994.
William A. Boehly,
Associate Administrator for Enforcement.
[FR Doc. 94-23872 Filed 9-26-94; 8:45 am]
BILLING CODE 4910-59-M